Fertigungsstufen-basiertes Gestaltungsmodell für mechanische Bauteile
- verfasst von
- Kevin Herrmann, Tim Brockmuller, Paul Gembarski, Iryna Mozgova, Roland Lachmayer
- Abstract
Manufacturing restrictions limit the design scope of mechanical components during product development. Often, these restrictions are not completely known and can therefore not be taken fully into account during the design of component. This concerns in particular cross-process manufacturing restrictions, which arise when several manufacturing steps are chained together. This paper proposes a design approach based on knowledge about of manufacturing steps in order to provide a manufacturable component as early as possible in the product development process. The basis of this design approach are transfer models, which describe the manufacturing process chain against the later process direction. Thereby, intermediate manufacturing stages are derived step by step and their manufacturability is evaluated by means of suitable control mechanisms.
- Organisationseinheit(en)
-
Institut für Produktentwicklung und Gerätebau
- Typ
- Konferenzaufsatz in Fachzeitschrift
- Journal
- Stuttgarter Symposium fur Produktentwicklung
- Band
- 2021-May
- Seiten
- 247-258
- Anzahl der Seiten
- 12
- ISSN
- 2364-4885
- Publikationsdatum
- 2021
- Publikationsstatus
- Veröffentlicht
- Peer-reviewed
- Ja
- ASJC Scopus Sachgebiete
- Wirtschaftsingenieurwesen und Fertigungstechnik, Betriebswirtschaft und Internationales Management, Technologie- und Innovationsmanagement, Angewandte Informatik
- Ziele für nachhaltige Entwicklung
- SDG 9 – Industrie, Innovation und Infrastruktur
- Elektronische Version(en)
-
https://doi.org/10.15488/14172 (Zugang:
Offen)
https://www.sfb1153.uni-hannover.de/fileadmin/sfb1153/publications_zugriffsgeschuetzt/Hermann_2021_Fertigungsstufen-basiertes_Gestaltungsmodell_fuer_mechanische.pdf (Zugang: Geschlossen)
